Vehicle & Technical > Discovery

Discovery 1 snorkles

<< < (21/21)

Cassillis:
Did mine today as well :D
No need to put pictures up of the build as Iain C had done such a good job.
Mine's a 200Tdi so fitting to the airbox was easier. Pop out the old plastic air scoop from the inner wing, fit the adaptor supplied to the airbox, jubilee clip and silicone. Job done!

Sunday i shall be going out to test it. :twisted:

Oh just by way of a reminder, whilst working on mine i noticed the drain on the airbox was gaping as it was old. It's the rubber 'V' shaped thing at the bottom front end. Either replace it or seal it up somehow. If you do the latter check the airbox and filter periodically.

I know from bitter experience what leaving this drain open does to Land Rover engines  :cry:

Jake:
I do like the Southdown snorkel
My next off roader will have one fitted to it  :wink:
 :D

andrew2986:
been following this thread, will be ordering  a satin finish southdown on monday
 :D
Andy

lee celtic:
well here we are all finished and if I say so my self it looks cool 8)

Grand total £46 not bad for a steel snorkle  :D hardest bit I think is getting the nerve to cut the wing but once you start theres no going back.

Here are some piccies and I will put the rest in my gallery later :D

If your thinking of doing a home made snorkel I'd say go for it save some cash and have a one off bit of kit  :wink:

stuntman:
I'm with you lee, I've done it! Now just a wading kit to sort out  :twisted:

Navigation

[0] Message Index

[*] Previous page