Chat & Social > The Bar - General Chat

ROLL CAGE MATERIAL

(1/3) > >>

muddydisco:
What's the size of the tube that they use for roll cages. Is it easy to bend

cheers

datalas:

--- Quote from: "muddydisco" ---What's the size of the tube that they use for roll cages. Is it easy to bend

cheers
--- End quote ---


Err... no, not really, if it was then it wouldn't be much of a roll cage :D

muddydisco:

--- Quote from: "datalas" ---
--- Quote from: "muddydisco" ---What's the size of the tube that they use for roll cages. Is it easy to bend

cheers
--- End quote ---


Err... no, not really, if it was then it wouldn't be much of a roll cage :D
--- End quote ---


Will it bend with a 6 ton bender

smo:
Dont make a cage yourself, it needs to be designed properly, braced properly and welded to an axcellent standard, the chassis mounts MUST be beefy and the tubing needs to be of correct spec otherwise you are wasting money and risking your life with somthing that could fail when you really need it.

chris9119:
Do a search on here....., theres been loads on roll cages....

Look at the ARC/MSA sites, they have specs. for cages....

For what they cost already made, itr ain't worth doing it yourself.

Again, search on roll cages, theres some good bargains out there.

Chris

Navigation

[0] Message Index

[#] Next page