Vehicle & Technical > Discovery

And it gets even worse !!!!!!!!!!!!!!!!!!!!!!!!

<< < (2/2)

Eeyore:
So, how did you do it, dude?

Cheers
 8)
Eeyore

wizard:
I bought a few new keys and a timing pully from Bearmach.
Located the timing gear on the crank and tack welded the front key in place as this keyway was the one that was damaged.
I then ground the excess weld dowm with a Dremmel and took of the timing gear.
I filled the damaged keyway with weld and ground smooth, took out the key that i had welded in and re ground the keyway.
The crank pully that had a damaged keyway was then welded up and machined down, to a perfict fit.
The whole lot was then reassembled this morning.

A Dremmell must be the best tool in the world.

regards
wizard :twisted:

muddyjames:
sounds tricky to do but well done.

Navigation

[0] Message Index

[*] Previous page