Vehicle & Technical > Discovery

MOT Quicky

<< < (2/3) > >>

hobbit:
Some of this problem can be down to the tester really, generally you should be ok, but if it headlight mountings, battery plate mountings etc, it may be a different ball of wax

daveyravey:
Yeah, i know where you're coming from Hobbit.
It's where it slopes down towards the bulkhead that's rusty.

cardiff_gareth:
It will fail the MOT.

Drivers side has the master cylinder right by it and also the brake pipes run along it. Passenger side has something on it, I can't remember what it was but again will fail.

Mine did and I had to weld em up, nice job, it was lovely :(

hobbit:
Inner wing welding is a doddle on these anyway

Just pop the door off and unbolt the wing, will clear a way to access the whole inner wing from the outside

I had to replace the whole corner of the headlight/battery tray and body mount from the corner of the rad round to the front turret, not a lot of cutting, also repaired the holes round from the turret to the door pillar

daveyravey:

--- Quote from: "hobbit" ---Inner wing welding is a doddle on these anyway

Just pop the door off and unbolt the wing, will clear a way to access the whole inner wing from the outside

I had to replace the whole corner of the headlight/battery tray and body mount from the corner of the rad round to the front turret, not a lot of cutting, also repaired the holes round from the turret to the door pillar
--- End quote ---


Yeah, doesn't seem much to that job. All landy's bolt together.
Disco's are still kinda new to me, even though i served my time on old series Landy's. Usually with a liberal covering of dung   :lol:

Navigation

[0] Message Index

[#] Next page

[*] Previous page