Vehicle & Technical > Mitsubishi
pully replacement
rr bitsa:
Thankyou all.
Got one being delivered from milner tomorrow.Now have to try and get whats left of the old one off.
Cheers Paul
EvilEd:
Good luck mate, hope it goes okay.
Try and make sure you use a 6point socket on the bolt rather than a 12 or 18 as it is usually very tight and you'll round the bolt with multipoint sockets.
Don't forget to shorten the new bolt too and put some threadlock on there.
You might want to do a before and after shot of your knuckes too..... Just so you remember what they used to look like :)
EvilEd
rr bitsa:
Cheers evil ed.Need to get a socket to fit first. none of the ones i have that fit are strong enough.Knuckles they are only cosmetic.
Cheers Paul
Navigation
[0] Message Index
[*] Previous page
Go to full version