Vehicle & Technical > Defender

Cambelt kits

<< < (2/2)

CJ:
For decent quality bearmach stuff try this > www.mailorder4x4.com

 :oops:  :wink:

muck_truck:
i got a kit from paddocks.  hmm  i'll go have a look

Do a search for TIMINGKIT200DEF thats what i got and it had everything you needed.

only thing i remember is the tensioner was slightly different and you'll need a spacer or couple of washers on the bolt that holds the tensioner in, unless its a different one now.

extreme90:
rob, you can get them from paddocks or mm4x4
but make sure you get a lower crank seal and timing chest seal too, as its appart you might aswel replace um, rather than 1000 miles down the road  :wink:
dan

TDi90:
thanks dan.
where do i get the seal's from?
same thing as gaskets right?

extreme90:
ah well.....the gaskets i dont use and wont use  :lol:
i use rtv on the timing case cover, i make sure absolutely no water or crud can get in the chest to rip the belt apart  :shock:

as for the seals, some times they come with the kit, some times they dont, just ask them for a front crank oil seal and a timing chest cover seal

it makes sense to do it really when its apart, wel it does to me  :P

o another thing i do now to forign engines is remove the blinning cam gear retaining bolt and locktight the ******  :shock:
i had a cam dissapear off into the block and pop its head out at the other end on one engine cos the bolt slackend off then stripped  :shock:

dan

Navigation

[0] Message Index

[*] Previous page