Vehicle & Technical > Discovery
fuel tank fitting
hippi:
had a bit of a leak in my 200tdi just got second hand tank how difficult is it to fit will go through the haynes manual but any little things i may well come up against cheers
chris9119:
hippi
rusty nuts :wink: , spray loads of wd about.
You will need to access top of tank (through inspection plate in the floor) so you can get to feed and return pipes, sender connection....., these will be covered in muck and corroded....., take care not to snap them off or damage threads, etc......
The fill pipe is best accessed via the side bulkhead lining (in the back, from inside) from the fill cap end....
Chris
cardiff_gareth:
If its the same as a 300tdi the tank is held on as well by a large metal strap that goes over the tank and is bolted onto the chassis either side of the tank.
chris9119:
--- Quote from: "cardiff_gareth" ---by a large metal strap that goes over the tank
--- End quote ---
Mine goes under the tank......, to stop it falling out :wink: :wink:
Chris
cardiff_gareth:
--- Quote from: "chris9119" ---
--- Quote from: "cardiff_gareth" ---by a large metal strap that goes over the tank
--- End quote ---
Mine goes under the tank......, to stop it falling out :wink: :wink:
Chris
--- End quote ---
Maybe it goes over and under the tank, I remember seeing it when I had the floor pan out, painted it silver which looked cool and then I put the floor pan so it was a waste of time :lol: :lol: :lol:
Navigation
[0] Message Index
[#] Next page
Go to full version