Vehicle & Technical > Range Rover

prop rub

(1/1)

jay118:
I had to change one of my core plugs the other day , so while under the rangie I thought I'd have a good look round to make sure everythings ok . Then I noticed my front prop has been rubbing on the tubular cross member in front of the T case can I notch this out so it don't rub? or is this not advisable? thanks Jay

thermidorthelobster:
Take a look at your engine and gearbox mounts.  You may find one has failed, changing the geometry of the prop shaft.

jay118:
Sorry forgot to say its running 2" lift and castor correction arms looks like its rubbing on full droop not all the time I should have been a bit clearer , engine mounts are all ok and gearbox looked at them all . Just wondered if anyone else has had this problem . thanks Jay

Range Rover Blues:
Mine gets way too close to the anti roll bar, so I spaced it down by 2" but the gearbox cross memeber should be too far back to be a problem.

jay118:
strange . I think I'll take it to my local LR garage let them have a look , see what they say . Thanks Jay

Navigation

[0] Message Index