Vehicle & Technical > Range Rover

Pressure in water system

<< < (2/3) > >>

Yoshi:
See now mine is the opposite, its not using any water now, and that top pipe is limp as anything, took the old girl out for a fierce run yesterday, did some stuff that would really make the temp rise, and nothing happened, stayed at the same temp the whole time (like it used to before the old rad blew) yet this top pipe stayed limp and you could easily squeeze it, but when i did squeeze it you could hear the water bubbling from the air i pushed through in the reservoir.

zulublue:
I think the temp issue is down to following instructions, as when the viscous fan was on, the guage went to around 1/3 of max, now on the kenlowe instructions it say take it to about 2/3 then kick the fans in to set the guage, so I now must assume the guage is out!

Range Rover Blues:
I set mine so that they don't come on when I'm driving along with air going through the rad, as soon as I stop and the temp goes up a little they come on.  Otherwise they will be on when you are driving and you might as well keep the viscous fan.

zulublue:
Yes, sounds like I have them set too high then.

Range Rover Blues:
If they come on with the needle still on the guage then maybe not, the electric fan switch on the A/C cars is set quite high :?

Navigation

[0] Message Index

[#] Next page

[*] Previous page