Vehicle & Technical > Discovery

A Little Exhaust Assistance Required

<< < (3/3)

Range Rover Blues:
Yes we used to order COBALT drill bits for sheared studs.

IRC the thread is M8 so a 7mm drill bit should do the job.

Tyke:

--- Quote ---IRC the thread is M8 so a 7mm drill bit should do the job
--- End quote ---






6.9 to be precise . . . . for a 'new' thread . . . . I'd go for a 6.5 max . . . . unless your confident the drill wont 'drift' . . . . then run a tap through it  . . . . before the welder comes out as as the last resort . . . . :wink:

jaws:
sure mine was m10 bolts but it doesn't matter anyway the job got done an doesn't blow!

tyke u goin for the drive on the 28th cause some havoc on the humber bridge? think a few of us are meetin up sat nite!  :wink:

Navigation

[0] Message Index

[*] Previous page