Vehicle & Technical > Suzuki

Inlet manifold / coolant

<< < (2/3) > >>

StuartL:

--- Quote from: "Evilgoat" ---There should be a hex-plug in the maifold at the bottom of the thermostat housing.
--- End quote ---


I have wondered what this is for before as a result of doing my radiator R&I.  I figured it may well be a bleed plug for the cooling system but I didn't want to remove it without being sure!

Evilgoat:
As Promised



Thinking about it I'm sure the heater feed is at the other end, your heater working ok?

minimog:
there is a freeze plug that pops out if the water in the manifold freezes and stops it cracking the manifold its proberly rusted out im sure you could get one from the dealer and they just tap back in

Mighty_zuke:
Ok, Seen the pic and thats not the bit I'm on about. I'll try and get a photo during the week! The hole is facing down on the underside of the inlet manifold for the piston closest to the bulkhead! Doesnt seem rusty at all!

Mighty_zuke:
This is where on the manifold the hole is, But underneath. I have to climb under the zuke with my head behind the off side wheel to see it!

Navigation

[0] Message Index

[#] Next page

[*] Previous page