Vehicle & Technical > Discovery

New Rock Sliders waiting to be fitted

<< < (3/3)

cardiff_gareth:
keep em cheap so its up to the seller to galv them if they want to, that way you can sell to a wider spectrum of customers, what sort of price would the cheaper ones be...... :?:

Guardian.:
wizard, you will need to have them to fit the sills not straight. ours were origionally straight but it did stop lots of people buying them i found.
they will still sell but limited market.
all the best
spence

Telaren:

--- Quote from: "Guardian." ---wizard, you will need to have them to fit the sills not straight. ours were origionally straight but it did stop lots of people buying them i found.
they will still sell but limited market.
all the best
spence
--- End quote ---


They confused me when I came to fit them but soon realised that they where angled.  :oops:

Just a bit of feedback though - On a 5 door the sliders leave a gap between the rear door sill and the slider.
Easily solved by cutting up the old plastic trim and fixing on.

Once again thanks for the sliders.  

Might be in the market for a front winch bumper as I have gone and bought  a winch  :lol:

Cheers Taz

wizard:
The set in my picture fit over the sills and there is a slight angle towards the front.
The 1st set i made i tried to curve the box section to match the body line but it was difficult to get two curves identical.

wizard :twisted:

Navigation

[0] Message Index

[*] Previous page