Vehicle & Technical > Range Rover
coil help!
shaun and co:
just bought a rrc engined project with a smashed in front end including the coil. Now i have a coil from my old 3.9 v8 disco but will this work in a 3.5 v8 rrc as one is capacitor and one is resistor? also where should the wiring to the coil come from and go to? any ideas gratefully recieved!!
Range Rover Blues:
--- Quote from: "shaun and co" --- one is capacitor and one is resistor?
--- End quote ---
Eh :?
shaun and co:
white ceramic block- i assume its a resistor whereas the disco one has a little capactor attatched to it?
Range Rover Blues:
Ah, that's a ballast resitor so I assume it has points on it then. The coil won't work without it (it'll burn out). The 3.9 will be fully electronic and a 12volt coil, that can be swapped with ther old coil and resestor (resistor styas with coil). If it's electronic on the older car too then you should be ok with the newer coil.
the capacitor is just a supressor, radio interference, that can be fitted to either car.
shaun and co:
sorry for being thick but are you saying that the 3.9 coil will go on the 3.5 and it replaces the ballast as well? and if the capacitor is just a suppresor can i leave it off as i have no radio in the car?!
Navigation
[0] Message Index
[#] Next page
Go to full version