Chat & Social > The Bar - General Chat

Humph!!!

<< < (4/4)

muddydisco:
Well for what new bearing cost . I would replace them you don't know if any bits are in there, you dont want to strip it again do you.

extreme90:
wel, all the little filings would have found themselves inside the bearings, so its either do it while its apart, or strip it in a month or so when they whining  :roll:
likewise wheel bearings aswel mike :wink:
u doing it yourself ?
practice on a old diff 1st, not to balls anything up, but ull no when the backlash and pre-load is right, itll just feel right by hand  :lol: , not to tight and notchy, not to slack and a s*** load of play (backlash)

dan

Navigation

[0] Message Index

[*] Previous page