Chat & Social > The Bar - General Chat

discovery head gasket + others

<< < (2/3) > >>

bezzabsa:
new bolts or old ones reused?
complete top end gasket kit or just head/rocker/manifolds?

mud-club-matty:
can re use old bolts but there is a risk in snapping them so i would go new   if u get a head gasket set its manifolds aswell etc but if you are haveing thermstat houseing off get a top end gasket set

extreme90:

--- Quote from: "bezzabsa" ---new bolts or old ones reused?
complete top end gasket kit or just head/rocker/manifolds?
--- End quote ---


me personaly i replace the bolts everytime.....spimply cos i dont like doing things twice  :shock:
its damn annoying refitting it all and then having to take it apart agen cos someone a tight arse and wont replace the bolts....yes i had the one person  :shock:
its just not worth it
yes they can be reused upto 3 times if not more....but its not worth it

gasket wise, head gasket, rocker and inlet/zaust should cover you  :wink:

dan

ChrisW:
Torque wrench is an absolute must, don't try and fluff it or you'll end up snapping something.
Dial guage or make your own.
Feeler guage for checking/adjusting the tappets
32mm(?) socket for turning the engine over to check the tappets
Marker pen or tippex to mark the new bolts when you torque the new head down
Piece of cardboard and tape to tape the valve caps and push rods to in order of taking them out
Second battery for when it won't start until the fuel starts coming through again
Day or two to get the head pressure tested and skimmed
Lots of money when you find out the head is scrap  :roll:  :lol:
Read the book three times before even attempting to undo the first bolt

Other than that I've done it twice with a regular tool kit easily enough.

electricbluebadger:
Definately worth getting the head checked whilst its off, they have a habit of warping if it overheated and its rather annoying (to put it mildly) to reassemble only to find its warped and youve gotta do it all again.

Also check how many holes you have on your indicator tab on the gasket as it may be possible its already been skimmed to the max amount and wont take another skimming , i think one hole is the thinnest gasket , 3 the thickest but double check cos Im not certain which could be 1 is thinnest??

Cheers Steve

Navigation

[0] Message Index

[#] Next page

[*] Previous page