Vehicle & Technical > Freelander

immobilser problem (sorted)

<< < (2/2)

alankennedy10:
sorted damaged cabling at the imobiliser ecu was the cause of fault.

so heres my day i explored my motor and found damaged wiring in leads running from  the mobilier ecu

they would appear to hve rub up on an edge of the body work barring 2 right back to the cooper and shorted out on said body work.

thinking back i remember the wife said one day it apeared dead so has been developing over time makes sence as the cables wear throw.

when pulled of of body car started no problem let them loose and they pushed back onto body car no start.

so i cut soldered and shrink rapt them and cable tyed out of danger

all appears to be ok after much immobilising and unimobilising so laind it this afternoon to give it a bit rattle about all good.

much happiness that this was nothing major can now say if been round the hole car with a fine toothcome now amazing how much mud is hidden in some of the corners on it. realy needs a dam good clean make that this weekends job before go out in it again

thank fully this was an easy fix when i found the fault.

hope this might prove helpfull to someone else at some point.


thanks to carbore for taking the time to look up stuff and offer email help.

Navigation

[0] Message Index

[*] Previous page