Chat & Social > The Bar - General Chat

Which Plasma Cutter??

(1/1)

L90OOK:
I want to get myself a plasma cutter for chassis, bodywork & fabrication of my own vehicles.
However...I have no experience of these machines :roll:
So...Your input on a good machine would be welcome...cheaper the better too   :?
Cheers

Bulli:
these things never seem to go cheap, no doubt someone will no where you can get one though!

muddydisco:

--- Quote from: "L90OOK" ---I want to get myself a plasma cutter for chassis, bodywork & fabrication of my own vehicles.
However...I have no experience of these machines :roll:
So...Your input on a good machine would be welcome...cheaper the better too   :?
Cheers
--- End quote ---


Which one are you thinking of going for the one with the built in compressor or not. I would go for the one with the built in compressor. There one called the drag-gun picture of a dragon i here these are great.

It's on ebay item numer 280093846256

Xtremeteam:
got a snap on one which runs of the garage compressor,wasnt cheap looking at £500 to buy it 2nd hand now & over 1k new

L90OOK:
Cheers guys

I was looking at under £500 if possible...I have a compressor so either machine would be ok.
Have been looking on flea bay but don't know the pros & cons of each machine!  :?
What sort of Amperage sould I be going for?
Thanks

Navigation

[0] Message Index