Vehicle & Technical > Discovery

Intermittent, intermittent wipers

<< < (2/2)

discomac:
my intermediate setting has never worked and passed its last three mots

hobbit:
As long as they work and in good condition you should be ok with the mot, however the motor assembly are not hard to change

Wipers off spindles, retaining nuts on spindles off, front plastic cover and then the whole assembly will come away from the body with 5 screws, on my 200 the wiper motor off a classic rangey will fit it, you just have to replace the motor into the assembly

gb0wers:
I went to change my front wiper motor a couple of weeks ago because of this. The new motor had a different plug on it so as I was going to have to mess about I decided to mess about with the old one first.
It was easy to drill the rivet heads off the gearbox and expose the internal switch contacts. I cleaned everything up and bent the two contact springs to increase the contact force.
To box it up I didn't have to mess about with re-riveting it as next to each rivet there was another blind hole in the casing (which I drilled through) and holes in the cover plate to match. I used small screws and nuts to hold it together, oh, and lubed it with vaseline.
Works a treat.
Cheers
Graham

BigA:
Thanks for all the replies, at least it doesn't look like i have to worry about it for the MOT, i will just put up with it for now.

Thanks again.

Navigation

[0] Message Index

[*] Previous page