Vehicle & Technical > Suzuki

PIC'S of a standard 413 samurai carb fitted please!

<< < (2/2)

Gaz-M:
ok, if thats the views on them then ill try to sort the SU out!

Right, where do i see these codes, guess itll be stamped on the needle?

Thanks btw! :wink:

wheelspinner:
Suzukitech   http://www.suzukitech.org/ have a carb section may be worth a quick look to help set it up

I think the code you are looking for is FZX1409 normally on a little plates attached to the carb, normally found on 1.3 metros and maestroes

try the codes in here http://burlen.co.uk/store.aspx

Suzukiclubuk have a section on modifying the SU vac advance this could also help with your stalling problems

Regards

Steve

Gaz-M:
Just checked, mines is an FZX 1414.

Looked it up on that link, it has:

Carburetter: FZX 1414 Total Carbs: 1
Make: Metro Model: 1000
Year: 1982 - 1982 Engine: 1000cc HLE
Set Part No:  Type: HIF38


Is that my problem?  The one you stated is for a 1300, mines is for a 1000!

Hmmm.... Is the HIF44 a 44mm body and HIF 38mm?

So ill at least have worse off performance than the HIF44..

 :wink:

wheelspinner:
If your motor is a 1300 (if its a sammy it must be) then you need the HIF44, no wonder it was running poorly...... :(

The HIF38 is for a 1 litre

nip down the scrappys and get a hif44.......

Regards

Steve

Navigation

[0] Message Index

[*] Previous page