Vehicle & Technical > Discovery

300Tdi/ 200Tdi Help Please

(1/2) > >>

MZ6666:
Hi folks,
What mods/parts etc do you need to do to fit a 200Tdi lump in a '97 300 Tdi manual Discovery (with cable operated injector pump) ?
Cheers,Rich

Range Rover Blues:
Syrely that depends on how much you got with the engine.  If it's a "turn key" engine then probably not a lot.  Are the engine mounts the same?

MZ6666:
Don't know.
I've just bought a Disco with a iffy motor (no water/poss no compression) and wondered what sort of job it would be.
I think rad/intercooler/coolant pipework are different

hobbit:
Rad/intercooler assy is different on them, but generally you should be ok if you have the whole vehicle to cannibilise for the necessary parts, the only thing is as far of what little knowledge of the 300I have, is the sensors round the engine

extreme90:
engine mounts are different, so you would need to chop some engine mounts off a disco 200 chassis and aquire the 200tdi disco engine mounts if you aint got um, ( ive got them if your stuck )

gearbox crossmember is different afink...but am not quite sure, aint been under a 200 disco for a while  :P

loom wise, the 300 tdi ones will plug into the 200 stuff, only 7 wires  :roll:

box, would be better to use the lt77, not sure about props  :roll:

so is it the 300tdi u got thats duff ?? what exactly wrong with it ? want sell the engine and box  :P   :twisted:

dan

Navigation

[0] Message Index

[#] Next page