Chat & Social > The Bar - General Chat

fitting rivnuts without a tool?

(1/3) > >>

vtrdaz:
Is it possible to fit these without an expensive tool - tried a couple of ways with bolts and washers but they never seem to take properly.

Any ideas? :roll:

Cheers
Darren

solihull-mick:
can use my fitting tool if you want?

blackbob:
use a long bolt with a washer and a nut and two spanners

Porny:

--- Quote from: "solihull-mick" ---can use my fitting tool if you want?
--- End quote ---



Or mine  :wink:
Can do up to M10....


Ian

Sheddy:

--- Quote from: "blackbob" ---use a long bolt with a washer and a nut and two spanners
--- End quote ---


TWO washers and plenty of grease between them.

Navigation

[0] Message Index

[#] Next page