Chat & Social > The Bar - General Chat

SNAP-ON MIG WELDER

(1/2) > >>

muddydisco:
THINKING OF UPGRADING FROM A CLARK 151 TURBO TO A SNAP-ON 2180 SX 240 VOLT 180 AMP. HAVE ANY OF YOU USED SNAP-ON WELDER AND HOW GOOD ARE THEY.

hairyasswelder:

--- Quote from: "muddydisco" ---THINKING OF UPGRADING FROM A CLARK 151 TURBO TO A SNAP-ON 2180 SX 240 VOLT 180 AMP. HAVE ANY OF YOU USED SNAP-ON WELDER AND HOW GOOD ARE THEY.
--- End quote ---


Exactly the same as Cebora units, with an expensive badge.  
I have the Cebora on and it is pretty good for a single phase unit, works well when used in both high and low settings.

Steve

Daz800:
I have a mac tools mig welder, great bit of kit.I can turn it into a tig welder (when i get time to buy the tourch, but why should i if i can use any welding plant at work).
Had it about 5 years and never let me down.

Darryl

tomarse:
I really want to buy a cebora one to replace my crappy Ferm one. I used my mates cebora 130 quite a bit and it was so nice comnpared to mine (though mine cost under £100 new which probably explains a lot!)

Guardian.:
the snap on 180 amp for a little welder is a crackin bit of kit, i had one a few years ago couldnt fault it, ran a treat.
have to say though, the sealey are just as good and half the price, had one of them also, if buying a littlun again it would be the sealey save plenty of lolly that way.

Navigation

[0] Message Index

[#] Next page