Vehicle & Technical > Defender

Rear trailing arms

<< < (2/2)

rollazuki:
Sleeve it if you can and bend the [!Expletive Deleted!]?
Bend it and run a section of angle on the underside as a stiffener?
Im sure theres plenty of ways you can restore strength into the mildly bent arm.


If it shortens the arm, itll pull the bottom of the axle forewards slightly, thus service to point the diff nose upwards. Maybe you will get a little prop vibration? There is no camber setting as such,for the rear axle.


Get a pair of second hand arms and do a trial bend, see how they go, see how the bracing needs to sit.

Muddy:
C'mon spinks i'm sure you and dex can knock some up!

I have added you on msn by the way hope you dont mind. :)

Navigation

[0] Message Index

[*] Previous page