Vehicle & Technical > Mitsubishi

Tortion Bars?

<< < (4/4)

markyd:

--- Quote from: "HSimmo" ---If i crank my torsion bars up an inch or so, is it necessary to get an alignment after?

Have been told different things.
--- End quote ---


ive gone up a couple inches at the front, and my tyres are fine. Dont think it would hurt to have em checked to be sure.

if the Mk1 is the same as the Mk2 jack the front up to take the stress off the front, you will 2 17mm spanners to undo the lock nuts. Adjust the thread to you are effectly turning the bolt into the assembly, repeat on the other side. Dont go up more than a couple of inches, as it down place stress on your cv' joints and boots. Check that each side is exactly the same by measuring from the middle of the hub to the top of the wheel arch each side. You will find the ride err stiffer, and firmer, but in a good way :lol:

hope this helps :wink:

Mutz:
Didnt think Mk1's had torsion bars!!!!

markyd:

--- Quote from: "Mutz" ---Didnt think Mk1's had torsion bars!!!!
--- End quote ---


yep they do, its in here somewhere :lol:

http://www.pajerouk.co.uk/tech_gen1spec.htm

Navigation

[0] Message Index

[*] Previous page