Vehicle & Technical > Discovery

Advise!!! - fitting steering guard to disco.

<< < (2/2)

Hightower:
Phil,

You could always do what Colin did and take your friends Disco for a spin around Aston Cantlow and remove the front valance that way !!!!   :twisted:  :twisted:

(Sorry Colin)

wifey:
Actually Phil, I bought a new heavy duty front bumper at the same time as the steering guard.
The steering guard (from Scorpion) was a very tight fit and the most difficult part of the job, but hubs and I managed to do it ourselves in an afternoon.

Frankie-Boy:
Phil,

I've got a Southdown steering guard on my ES, I didn't have any problem with the valance at all, the only problem we had was undoing the long bolt that goes through the steering box mountings, it was "FT", so beware if you have to get that out.

Also I had to re-arrange the tie down loops that are welded to the chassis just where you have to put the guard, (BIG hammer).

Good luck.

turtle:
Thanks for all your advise.

Will let you know how its goes.

Cheers

Navigation

[0] Message Index

[*] Previous page