Vehicle & Technical > Defender
Gonna be busy, me thinks...
Xtremeteam:
--- Quote from: "bigfatsi" ---Has anyone on here made their own downpipe? I ask because I think over £135 is a tad much! I have the disco downpipe but I don't have any other bits of pipe hanging around. Will this do?
Simon
--- End quote ---
i made my own downpipe out the cast elbow to allow the fitment of a modded disco front pipe,only thing i found was after a hard landing offroad the exhaust would drop off
as yours is a TD to start with reuse the oil cooler pipes :wink:
the radiator is in the same place & the oil filter housing is in the same place
if they dont fit (they should) get a pair of defender tdi oil cooler pipes as they go straighty in
Muddy:
AFAIK a td5 downpipe cn be cut and shut to make your own, will take a few hours but defo cheaper.
Xtremeteam:
--- Quote from: "Muddy" ---AFAIK a td5 downpipe cn be cut and shut to make your own, will take a few hours but defo cheaper.
--- End quote ---
dont see how as they go straight down but hey
Muddy:
I think you can cut some wedges out and weld up mike i know it wont fit as standard.
90sam:
So if i bought a disco 200 tdi engine and bought an exhaust from steve parkers, the it would be pretty simple afterwards? There is also another kit to convert but its like £300 - odd quid :o !!! Need to do it on a budget of £600 and then replace the gearbox!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version