Vehicle & Technical > Toyota

HiLux injector pump

(1/2) > >>

JimAlex:
:?: I have a leaking injector pump (1989 2.4) and am trying to remove it but have discovered that the drive gear is on the shaft with a taper and woodruff key. Is it possible to break this taper without stripping the front of the engine? There is a round access hole in the cover.

JimAlex:
:D Solved it - but I will now need a timing diagram to put it back together!

Ja1983:
D`oh!

dismantle everything then yes?

may aswell replace belts etc as your there  :wink:

plumb bob:
Did you get the leak fixed, I have the same problem with my '89 2.4 2LT.

Been looking for a replacement pump, but they are like hens teeth.

Did you use a seal kit, and if so where did you get it, and is it an easy job?

Let me know how it goes.

Woodzie:

--- Quote from: "plumb bob" ---Did you get the leak fixed, I have the same problem with my '89 2.4 2LT.

Been looking for a replacement pump, but they are like hens teeth.

Did you use a seal kit, and if so where did you get it, and is it an easy job?

Let me know how it goes.
--- End quote ---



Give tony a shout.......... http://www.4x4toys.co.uk/

Navigation

[0] Message Index

[#] Next page