Vehicle & Technical > Discovery
Advice needed (antiroll bar mount) - Fixed now
thermidorthelobster:
Ah, I'm with you now. Can't get a bottle jack in there to force it out the way?
jnoshea:
Tried the bottle jack. Not enough room to get in there with it.
I'm going to try drilling two new holes forward of the old ones on the bracket to compensate, I'll let you know if it works.
gtomo2:
bent my front ones back into shape with a bottle jack.just face the car to a kerb chock the rear wheels and wedge the bottle jack between the kerb and the mount at a nice angle then just pump the jack up and away you go.
J.D.:
Either that or I know someone did theres with a Hi-Lift Jack in the same wya.
jnoshea:
Tried the jack thing, couldn't get an angle that wouldn't just make it worse. I opted for drilling new holes forward a couple of cm from the old ones. Brought the ARB back into alignment quite nicely...couldn't get the old bolt out though, sent the wife to get more hacksaw blades :)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version