Vehicle & Technical > Discovery
New Boots Fitted To Disco
Telaren:
--- Quote from: "Disco-Ron" ---Taz,
What size are those Modulars, and what is the offsett...... i've got a set of 285 75 16's in the garage waiting to be fitted to rims, but i can't get what i want.... i need wide wheels, with a negative offset, i do trialing, and i can't use spacers..... so i need to wheels to be further out to start with, your's look like the most 'sticky outy' ones i've seen.....
--- End quote ---
My rims are 7x16 modulars (Without fake cap heads round rim)
The measurement from the outside edge of the rim to the back of the centre flange is 100mm
Will post a close up piccy later.
Hope this helps
Taz
Telaren:
Finally New Boots Fitted :D
Before :cry:
After :(biglove):
Taz
muddymart:
hi mate, what tyre size did you end up getting and did you have to do any mods ? theyr'e what im after, looks pretty good,mine just standard at the mo'
Cheers
Martin
Telaren:
--- Quote from: "muddymart" ---hi mate, what tyre size did you end up getting and did you have to do any mods ? theyr'e what im after, looks pretty good,mine just standard at the mo'
--- End quote ---
Martin
I ended up getting a set of Modulars (Offset Dim = 100m from rim edge to back of centre flange - giving approx 30mm offset) :D
The Tyres are 235/70/16 Insa Turbo Sahara from Paddocks :shock:
They look spot on especially with the modulars - makes them look wider than they are. 8)
I have done NO Mods to the Disco - It is totally standard (Apart from diff and steering guards).
The lock has not been affected and I think I could get a better turning circle than with the alloys. :roll:
I am only looking at doing a few play days and the odd TYRO / RTV and Green Laning
so these should do the job spot on without breaking the bank.
Taz
muddymart:
sounds good, exactly what im after, as i too "dont want to spend loads" just the protection ,tyres etc...looks pretty well,i think someone has had oversized my disco before as it has a crease on the o/s/r rear quarter behind the wheel which im going to have to cover with chequer plate.
hopefully i can get my set this week !!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version