Vehicle & Technical > Discovery

Removing disco carpets? Anyone left them out?

(1/3) > >>

spy:
Seen as I dont seem to be having much luck with my dirty old disco on ebay I have decided its time to get on with sorting it out.  

How difficult is it to remove the carpets?  I know there are two plastic strips sort of above each sill thet need to come up but what else?  

Has anyone taken them out cleaned them and refitted without too much grief?  

Thanks,

Mike

PS. Yes they are too bad to clean in situe, think I really need to jetwash the mud off!

dazzawhipple:
Just replaced my interior inculding carpet, you will have to remove centre consul, both front seats, rear seats and all the door edges.
 it will then lift out in 2 bits but you may have to cut the carpet onto of the tunnel at heater matrix end

Expect the soundproofing to be sodden

Darren

spy:
Sod that then!  Sounds like a nitemare :(

dazzawhipple:
it is

spy:
Well, it would be much easier with a stanley knife!  

Anyone not got carpet at all in their disco?  Thinking of cutting it out and binning it.  Had series landies without carpet, much easier to clean out.  Surely it cant be noiser or colded than a series 3?

At least I get a good look at the state of the floor.  Anyone suggest a good heavy paint to coat it in? almost bitchumen (thats not spelt right is it) based?  

If anyone has no carpet and could take a few pics it would be much appreciated!

Navigation

[0] Message Index

[#] Next page