Vehicle & Technical > Defender

Light bar

(1/2) > >>

locknut:
I'm fitting a light bar on my defender....question is where do i run the cables from, do i run them down the side of the snorkle and put them through the upper wing corner or do i drill through the side of the windscreen panel and run them down and behind the dash ? :?

Paul:
Run them down the outside of the snorkel. :wink:

locknut:
I was glad somebody said that, i didn't fancy any more holes, enough water comes in already :!:

Needalanny:
what about sending the wires under the door seal and into the cab that way? Then you won't have to drill any holes in the body work and the wires will be inside the cab.

Just a thought. Thats what i did with the CB ariel wire. Works a treat, and no holes

Matt

Cassillis:

--- Quote from: "NeedALanny" ---what about sending the wires under the door seal and into the cab that way? Then you won't have to drill any holes in the body work and the wires will be inside the cab.

Just a thought. Thats what i did with the CB ariel wire. Works a treat, and no holes

Matt
--- End quote ---


AFAIR that's the way i did it too. Looks and works fine :wink:

Navigation

[0] Message Index

[#] Next page