Vehicle & Technical > Discovery

Transfer box won't stay in high range

<< < (2/6) > >>

extreme90:
all itll be is adjustment then o would have thought
now off top of my head to adjust high range you need to winde the nuts up the rod but dont go far go a half a turn at a time and try it
if no joy wip the top housing off and check the grub screw
dan

narked:
Ok, cheers mate. Will try that tomorrow.

doris:
Hi All

I have the same problem, only with low range, and have the shed booked in for a recon t box.

I have heard of this grub screw, but haven't been able to find it..........  but then I am fairly pants at nuts and bolts and the like.

Can anyone explain in words of few syllables how to find this fabled grub screw and how to fix it please??

Pictures would of course be great too?

Much Thanks

Damon

narked:
Big thanks to thebiggreenthing, got it sorted today. Was the two nuts needing adjusting. Quite an involved job altogether really for an idiot like myself. Had to take out the centre console, then remove the soundproofing around the levers, then actually find the linkage. And then I had the wonderful job of trying to get hands into the gap and a spanner onto the nuts and leave myself enough room to actually make adjustments! I though the upper nut was difficult, until I tried to adjust the lower one! (Couldn't even find the lower one at first!).

Anyway, all done and dusted now! And I have that wonderful sense of achievement, my first mechanical repair on my Disco :D

Skibum346:

--- Quote from: "narked" ---I have that wonderful sense of achievement, my first mechanical repair on my Disco :D
--- End quote ---


 =D>  \:D/
 =D>  \:D/
 =D>  \:D/
 =D>  \:D/
 =D>  \:D/

Navigation

[0] Message Index

[#] Next page

[*] Previous page