Vehicle & Technical > Series Land Rovers

HOT series 3 lighting switch

(1/2) > >>

MonsterLandrover:
i have recently put a halogen conversion on my series and have noticed that the light switch gets hot when the lights are on. is this usual??

AbyssDJ:
have you got higher wattage bulbs in it?

MonsterLandrover:
No. there 55/60w

AbyssDJ:
hmm... could be just because its old and not up to it i suppose. just rewire them with a relay and it should be fine

Bob Ajob:
Hi,

A halogen conversion should not be used without a relay, you are sending all the power needed for the lights through the light switch, and when on full beam through the indicator stalk.

The relay is switched by the light switch, and then it transfers all the power from the battery straight to the lights. It may be costly it if burns out the switch and/or cables.
Have a look here Vehicle Wiring Products, you should find something suitable. It's not a difficult job, will take about an hour or so.

Regards,
Rob.

Navigation

[0] Message Index

[#] Next page