Vehicle & Technical > Discovery

rear seat belt mounts

(1/2) > >>

mcb:
Dose any one know how i can replace the rear seat belt mounts as rusted out and will not pass an m.o.t like it.
and wotes the besy way of doing this  :?
thanks martin

redhand:

--- Quote from: "martin clive brown" ---Dose any one know how i can replace the rear seat belt mounts as rusted out and will not pass an m.o.t like it.
and wotes the besy way of doing this  :?
thanks martin
--- End quote ---


You'll have to cut out the rusted section and weld a patch over the hole. It will have to be a fully welded patch for an MOT. Then drill new holes for seatbelts and refit.

cardiff_gareth:
Martin,
What mounts have gone :?:

The mounts for the receivers in the floor pan or the mount for the actual seatbelt located by the rear door as you open it :?:

mcb:

--- Quote from: "cardiff_gareth" ---Martin,
What mounts have gone :?:

The mounts for the receivers in the floor pan or the mount for the actual seatbelt located by the rear door as you open it :?:
--- End quote ---

it's the mounts by the back door the mounting bolt the blet go's on to over the wheel arch

Bulli:
might be worth weling in or patching the area then welding in a thicker back plate for strength. The plate doesnt have to be huge but will give you more peace of mind.
Have a look at the plates they sell for mounting harnesses only about an inch and a half square.

Navigation

[0] Message Index

[#] Next page