Vehicle & Technical > Discovery

bodylift

<< < (2/2)

greendisco123:

--- Quote from: "wizard" ---This gives a good idea of what you need

http://www.roverunited.com/tech/rovertym-body-lift/rovertym-body-lift.htm

wizard :twisted:
--- End quote ---






BRILL SITE THANKS :D  :D  :D  :D  :D

Disco-Ron:
I was tempted by the kit these guys do... a bit expensive, but you do get eveything you need.....
http://www.rovertym.com/

dazzawhipple:

--- Quote from: "beast5680" ---
how did you extend the steering linkage if i may ask? or is there enough in it
--- End quote ---


The steering linkage has to lengthened weld and bolt (I have access to coded welders!!!)

Basicaually the following where issues for my lift

Transfer box lever needs extending I might yet do the gearbox one as well
I had to release the fuel filler pipe but went back on okay
The wiring above the engine needs to be released I made a spacer up
The Fuel filter needs to be dropped or the pipe from lift pump needs to be lenghthend (I dropped it as it cleared the clutch master cylinder better)
Rear bumper just needs a plate with a pair of holes the distance of the lift

Front bumper is a bit tricky if you have a steering guard fitted but fairly easy

Darren

JDB:
... not being the best with a welder but handy with a spanner - does anyone produce brackets for the front and rear bumpers - or would somebody make me some for beer tokens????

Thanks

Navigation

[0] Message Index

[*] Previous page