Vehicle & Technical > Discovery
Recovery Points
Tyke:
He,He . . . . another so called 10 minute bolt-on job . . . . Don't you just love it . . . :lol:
Range Rover Blues:
--- Quote from: "karlo" ---I'm not that well equiped, but i get by with one of these generally
--- End quote ---
Ok, do you have the Electric gas axe, aka Land Rover special tool #2 aka angle grinder.
karlo:
Large or small i have both.............. :lol:
hobbit:
Had the same problem on the hybrid recently, the one long bolt through for the o/s/r mounting was rusted through the chassis mounting
Loads of wd40, big 3/4 drive socket and breaker bar to crack it off, and then loads more wd and air gun it backwards and forwards for about half an hour to release it from the rust then tap it out, keep spinning and oiling, knocking it back in and out as you go to let the lube penetrate through the mounting hole
good luck :wink:
karlo:
I tried an air gun Kev, the nut comes undone but the bolt's siezed, i've only a little compressor so i have to let it build up each time, i'll keep at it its bound to come eventually but it is solid at the mo :shock:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version