Vehicle & Technical > Discovery

camel cut

<< < (2/6) > >>

mattyme:
yup.... good words jaws.... you only get one cut at it to get it right!! cheers mate!!

jaws:
hey like i keep saying mate "i'm trained!" :(biggrin):

gords:
Basically, I did mine by measuring 2" back from the wheel arch, at the bottom. I then marked a straight line to meet towards the top of the arch. I then used a fine hacksaw to cut it off. I smoothed it off and painted the edge black - job done :)

Oh yes, I also cut a triangle off of the horizontal bit of panel at the bottom. Otherwise it looked a tad dangerous to the tyre!!

mattyme:
cheers gords... ill bear that in mind too!!

rommelsraider973:
you'll only bend it on the 20th anyway!! :lol:  :lol:

Navigation

[0] Message Index

[#] Next page

[*] Previous page