Vehicle & Technical > Defender

Castrol Motorcycle Chain wax to waterproof my v8

<< < (2/3) > >>

wheeler:
hi the spray greese i used was high temp
so i guess non flamable i put this on drove 30 miles  off roaded all day and 30 miles back
and no probs
and will be using it again

wheeler:
your driving in mudy water and every other part on the rover is covered in mud   :P   :P any how i jet wash mine after every event and coat it again before i go offroading

unknownmanxman:
I can vouch for Spray grease, Viscolube i think its called.. I cant remember if its flammable or not.. But it worked a treat!

Snooky:
It's the stuff they use to make it spray that's flamable, if not it would be wax and won't come out of the can, so when spraying a bike chain it is more fluid, then the propellant (however spelt) and the other stuff evaporates to leave a wax coating on the chain :lol:
Hope that makes sense  :wink:

Angry Badger:
I use motorcycle chain wax on my Rangie to good affect and have never had problems.  Also have a rubber mat "guard" in front of dizzy.  It helps to have an air gap which you don't get when you use rubber boot covers like the 8 fingered glove because cold water hitting the cover/cap can cause condensation and make the problem worse.  Best way to water proof is to "vent" the cap by drilling two holes.  A breather pipe going to one and a vacuum pipe from the air inlet pipe (not the manifold as it will affect the mixture) going to the other.

Navigation

[0] Message Index

[#] Next page

[*] Previous page