Vehicle & Technical > Discovery

No ignition lights

<< < (2/4) > >>

gtomo2:
No your not been thick look against the inner wing under the wiring loom. it look like just some cloth wrapped around a seconed wiring loom. if you trace them back from the battery you will see the wiring loom goes from one to two looms follow the lower one and you will see it. Its normally in the middle between the font of the wing and the bulk head pined against the inner wing. If you still have no look i will take a pic of were and what it is. but cant do it til tomorrow as its dark and wet

MrBadger:
Thanks for that gtomo.

 I've called it a day cos its wet n windy here. I'll have another look tomorrow


Badger

MrBadger:
I've found it this morning - they're all intact and fine!

Anymore ideas would still be very helpful!!

Thanks for the help!

Badger

gtomo2:
could be the main wire going it to the alarm box it is soldered on to a post inside the alarm box this can come loose ( dry joint) and stop the alarm form working. do you still get the led flashing or is that dead as well?

MrBadger:
Hi gtomo2

Led light is dead as well ?

I've cut the immboliser out and still no ignition lights. I've now reconnected everything back and short of setting fire to it - I'm stumped!

Navigation

[0] Message Index

[#] Next page

[*] Previous page