Vehicle & Technical > Series Land Rovers

problems with my series IIa please help

(1/2) > >>

mikeh1975:
hi all

i have had some problems with my series landy, it had little or no breaks so ive changed all the fluid, and changed all the pads, the pedal feals a little firmer after a couple of pumps, but when you drive along it goes very spongy and sometimes the pedal doesnt work at all, any ideas?

thanks

mike

Devon-Rover:
Have a check of your adjustment. and also the pedal freeplay.

Jack each wheel up in turn and adjust them in turn. i.e. untill they lock then a couple clicks off, so they are just rubbing.

The pedal freeply is that when the brakes are off, the pedal should just be able to move up against the Pushrod on the MC.

mikeh1975:
we adjusted the drums but havn`tajustedthe mc how do i go about that?

thanks

mike



--- Quote from: "Devon-Rover" ---Have a check of your adjustment. and also the pedal freeplay.

Jack each wheel up in turn and adjust them in turn. i.e. untill they lock then a couple clicks off, so they are just rubbing.

The pedal freeply is that when the brakes are off, the pedal should just be able to move up against the Pushrod on the MC.
--- End quote ---

Devon-Rover:
If you have the haynes or the Workshop manual it should all be there under master cylinder free play and pedal height adjustment. If not say and i'll dig out the relevent bits off the S2C forum.

mikeh1975:
thanks i`ll have a look, and just incase can you post it please?

mike



--- Quote from: "Devon-Rover" ---If you have the haynes or the Workshop manual it should all be there under master cylinder free play and pedal height adjustment. If not say and i'll dig out the relevent bits off the S2C forum.
--- End quote ---

Navigation

[0] Message Index

[#] Next page