Vehicle & Technical > Discovery

Bobtail???

<< < (2/6) > >>

TDi90:
exactly. you could.

Xtremeteam:
All you need is a tape measure,a grinder & jigsaw,some 1 to weld the chassis & lots o bottle, :lol:

Range Rover Blues:
First off, where are you? you're not the only one guilty of this but if we don't know where you are, how the hell can we advise you?

Now, if you are anywhwere close I can muck in and help.  I'd do it for you if you are prepared to wait (and pay of course) but TBH paying someone to do the job will make the car WAY too expensive, such that a decent 90 would look cheap in comparison.

90sam:
Sorry, i'm new to using forums but i am from warwickshire so your very far away from me, thanks for the offer anways  :wink:
Now is it as simple as you all say, i have a friend who said he would be up for helping me, can anyone recommened me an angle grinder up for the job :) Anything else that i would need?
Sorry to keep asking questions and being a pain!!
Sam x

thermidorthelobster:
Hang on a sec, I'm all for having a go at things, but if the chap doesn't have an angle grinder yet, I think that bobtailing a Disco is probably not the right job to cut his teeth on.  There are plenty of things to mess up and quite a bit of welding to do.  I think this is a recipe for trashing a perfectly good Discovery.

How about practising on some other bits (like, does the rear floor pan need replacing, probably does) before diving in at the deep end?  Unless you don't mind risking trashing the truck, of course.

Navigation

[0] Message Index

[#] Next page

[*] Previous page