Vehicle & Technical > Series Land Rovers
disc brakes
muddy_90:
going to make it out of 15mm steel or cut the mount off a set of rangie axles ive got in the gardan and cast weld them to the series swivel housing
muddy_90:
few pics of the clearance of the disc and wheel.
mark.yellow.series.3:
keep us posted, i would like to do this to my series.
blackbob:
think it would be easyer to adapt some mounts onto the swivel pin bolts rather than welding to the housing
mark.yellow.series.3:
--- Quote from: "blackbob" ---think it would be easyer to adapt some mounts onto the swivel pin bolts rather than welding to the housing
--- End quote ---
i agree, welding onto cast is a very specialised job, requiring a furnace to bring the cast upto 500oC or so then welded with iron powder rods or something similar, then the cast must be cooled slowley over about 12 hours or so, iam not an expert but there is a complicated procedure.
best use good 'ol' nuts and bolts.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version