Vehicle & Technical > Series Land Rovers

disc brakes

(1/4) > >>

muddy_90:
Had nothing to do today so i thought about trying to make a disc brake convertion.



just need to make up a capiler mount.

ian_s:
so how have you actually done it?
is it just the hub carrier and disk off a later vehicle?

muddy_90:
its a rangie rear hub and disc on a series stub axle, just swapped the bearings from the series hub to the rangie but need to get an oil seal to going in the back of the hub also u'll need 24 spline diff and front shafts and 90 flanges

TEMPL4R:
Have you tried putting the wheel on and seeing how much room there is for the caliper?

Chris

blackbob:

--- Quote from: "TEMPL4R" ---Have you tried putting the wheel on and seeing how much room there is for the caliper?

Chris
--- End quote ---

i run swb rims on the animal so the calliper will clear the wheel
wot r u making the calliper brackets out of cos they take loads of stress torque ect

Navigation

[0] Message Index

[#] Next page