Vehicle & Technical > Defender

Head Rest

<< < (3/3)

Big G:
Had the seat out today and was in two minds then whether to hacksaw it of or not..... :shock:

drmike:
No, no, no - the hammer will work. Just makes sure you hit the right bit and use a drift that might have to fit inside the bit the headrest pushes into.

Mike

Big G:
OK Doc,

Will have another look tomorrow......cheers

Big G:
Sorted,

Took the seat out. Undid the cover by pulling apart the plastic connector, its like undoing those air tight freezer bags. Rolled the cover right up and found where the headrest slots into the seat. As doc said it was then a case of hammering the headrest bit that slides into the frame. Rolled the cover back down and pressed the plastic connector back together.

Have now got a seat that doesn't make me hunch forward, bliss. Am now cutting some 40mm box section to raise the height of the seat.

Thanks to all that replied......much appreciated...... :wink:

Navigation

[0] Message Index

[*] Previous page