Vehicle & Technical > Range Rover

Waterproofing 3.5EFI

<< < (3/4) > >>

L90OOK:
Bullfrog...sorry :?

Thanks for advice...

Anyone know about tapping & venting dizzy?

Cheers

bullfrog:
Have a look a an SJ one as they are done from factory. Drill small hole. Fit threaded flange and fit tube. A decent plumbers merchant will have small ( I mean small) fitting suitable for the job for about £1. a piece of screen washer tube would do.

hingmy:
copied from a thread in defender section i think (orig post by Eeyore)

http://www.rhel.co.uk/tomcattech/dizzy.htm

Range Rover Blues:
Don't tap and thread it, that implies the use of a METAL hose adapter, threaded in.  BAD IDEA.  Drill a hole, fit a rigid plastic tube that's a tight fit and use some silicone sealer.

Garth:
See Avitar


Silicon Grease around mateing faces (leads and cap)
Its dead thick so wont pressure wash off
Melting point is 200 deg plus
But its also insulator so dont use directly on electrical connections

Navigation

[0] Message Index

[#] Next page

[*] Previous page