Vehicle & Technical > Discovery
Lifted discovery, clearance problem.
Range Rover Blues:
Could also be that it's buiilt by Land Rover :roll:
Could be the eternal body lean
Are those tyres remoulds BTW?
cotefarmboy:
--- Quote from: "Range Rover Blues" ---Could also be that it's buiilt by Land Rover :roll:
Could be the eternal body lean
Are those tyres remoulds BTW?
--- End quote ---
Yep, Colway MT remoulds, wonder if they are slightly different sizes or it could be just that the tolerances were not that great when the car was built :roll:
cotefarmboy:
Bushes are fine, arms are straight so I will book in for an alignment check.
In the meantime I have trimmed the plastic sill finisher by 1cm and it clears fine.
Steve ray:
--- Quote from: "Range Rover Blues" ---Could also be that it's buiilt by Land Rover :roll:
Could be the eternal body lean
Are those tyres remoulds BTW?
--- End quote ---
I'll second that! - no two are ever the same, it's that "hand built" appeal that Landies have :roll: :wink: Just fitted 265/75x16's on mine - again lifted by +2" and the arches only just require trimming.
If bushes / arms are OK, it may just be Landy manufacturing tolerances, the stiffness of the springs may affect it and given the tyres are remoulds, they may well come up a little bit bigger than the marked size would suggest.
cotefarmboy:
Yeh, not going to worry too much about it as they clear OK now. Will get an alignment check done at some point though as I don't want to scrub the tyres down if it is out.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version