Vehicle & Technical > Defender

Defender rear X member

<< < (4/4)

Jimbo:

--- Quote from: "davidlandy" ---well its done

its 6mm thick plate behind the Xmember between the chassis rails the full depth of the member and connected to the rails on both ends, then it goes under the member and onto the outside of it. All seam welded

should take a bit to bend it !

 :wink:
--- End quote ---


Got any pics Dave ?

Jim

davidlandy:
will do some today whilst its all shiny from the fresh coat of coloured rust protector (paint)

Navigation

[0] Message Index

[*] Previous page