Vehicle & Technical > Discovery

ROOF LIGHT BAR

<< < (2/5) > >>

ChrisW:
Make sure the light bar is sitting flat with the ends at the lowest point,
These bits sit in the gutter so the bar itself is at the front of the gutter over the windscreen.


You then drill through the gutter where the holes are, and these bits go underneath the gutter and you bolt through the lot.


You'll probably need to cut the bottom of the bolts off or fit the bolts upside down so they don't affect the opening of the door.

Also a good idea to loose fit the lights you're using on it before drilling anything so that you know the lamps will fit without resting on the windscreen or anything.

Steven:
:D Thanks alot Chris we know now,  :oops: silly us we thought the thoughs long bits with two holes stod up on the gutters but know.  :)

 :lol: real good help thanks!!!

Steven:
cant wait to test them now, just have to get them wired in.

ChrisW:
It is a bit confusing with nothing to compare it to!  :D

Before I had a snorkel to run cables up the side of I had a roof rack with lights - I ran some 4core flex up the side of the windscreen rubber trim on the glass side and carefully drilled through the rubber and ty-wrapped the cable in place with some small 4" ty-wraps. Only replaced them once  :wink: and you had to look twice to realise there was a cable there.

If you run the cable up on the same side you would fit a snorkel if you ever do fit one it will hide the holes/cable anyway.

Steven:
pm sent to range rover blue

Navigation

[0] Message Index

[#] Next page

[*] Previous page