Vehicle & Technical > Range Rover

universal back box fitting

<< < (2/6) > >>

Range Rover Blues:
Ah, right then.  This 88 3.5 had the hanger where it should be but they were a funny rubber bush with a bolt through tat went into a special clamp around the exhaust.  All the 3.9s I've seen had ditched this expensive arrangement in favour of a normal rubber hanger like every other manufactirer uses, again in the sam eplace.

SO do you have a redundant hanger just behind the axle, possibly with 3 holes in the top surface?

jpc:
ok there is no bracket or evidence of there being a bracket above the axel,
the only bracket i can see is the one holding the tail pipe.a funny coinsidence is that my log book finaly turned up today and it defo says 3.9 as does the phelum chamber cover.so i must have a very early 3.9 ? .

fitting the exhaust will have to wait untill tomorrow now as its p***ing down


thanks for your gidance Range Rover Blues


jp :D

Range Rover Blues:
Anyway, the method you describe is what's called a scarfed joint, it's perfectly serviceable and exactly how I'd do it.

Let us know how it SOUNDS :D

jpc:
ok job done the joinis a bit untidy (my first time) but its on and well if you like how a subaru sounds your gona love it.it throbs  :D  :D

thanks for your advice range rover blues :D  

cheers




now for the next project stopping it cutting out every time i go through a puddle??? :oops:  :shock:  but ill save that for another thread........

Range Rover Blues:
Does it actually sound better than it did without the back box at all?

Navigation

[0] Message Index

[#] Next page

[*] Previous page