Vehicle & Technical > Discovery

Rear recovery

(1/4) > >>

SnakeLogic:
Despite the title, this thread has NOTHING to do with recovery from some bad Indian food.

Until I can figure out who will send a couple of bumpers to Japan, I'm going to try to make do with some Jate ring fittings.  The front chassis holes were easy enough to find, but I don't see where I'd fit any on the rear.  Anybody know?  

Also, I once saw some rear directional (mine are in the bumper) protection (I forget on whose website).  After crawling around underneath today on my lunch break, I couldn't see where I'd drill for the mounting screws.  Seems a mighty tight fit.

Does BritPart carry any good aftermarket winch bumpers?  My local dealer has an account with them.

Bulli:
They are where the rear tow bar fits, assuming you have one.
I would see about getting them from OZ as it must be cheaper to send from there. Arb are based there along with quite a few good manufacturers.

Sheddy:
scorpion racing post worldwide

Budgie:
Not a great picture but it gives you an idea of where to look.  :D

Jake:
Which bumper is that Budgie?
Disco parts?
If so, where did you get that recovery loop from?
 8)

Navigation

[0] Message Index

[#] Next page